闪烁体荧光传输特性对ETOF探测器性能的影响

为了对BESⅢ端盖飞行时间探测器(ETOF)的测试结果给出合理的解释, 采用Monte Carlo模拟软件包Geant4, 对该探测器测量高能带电粒子的性能进行模拟研究. 详细探讨了当粒子击中ETOF模块不同位置时, 其闪烁体荧光传输特性与探测器模块输出信号之间的关联, 以及PMT输出信号甄别阈值的选取对闪烁探测器本征时间分辨的影响, 并寻找可能的改善时间分辨的方法. 为进一步提高ETOF的性能提供参考.     

巯基乙酸锑配合物的合成与X射线粉末衍射数据指标化

一些锑和铋的配合物可以应用于医药研究[1,2 ] ,已合成了许多锑的有机配体配合物[3～ 7] ,但其中大多数没有生物活性。因此 ,研究锑或铋离子的配合物不仅对主族元素化学、生物无机化学而且对医药都有着非常重要的意义。我们用三氯化锑与巯基乙酸液相反应法合成的二巯基乙酸锑 (Ⅲ)配合物 ,其组成为ＨＳｂ(ＳＣＨ2 ＣＯＯ) 2 ,用Ｘ射线粉末多晶衍射数据指标化来研究配合物晶体结构[8] 。1　实验部分1 1　仪器与试剂ＥＡ - 1 1 0 6型元素分析仪 (意大利卡拉欧巴公司制造 ) ,Ｄ Ｍａｘ -ＹＢ型多晶Ｘ射线粉末衍射仪(日本理学 ,ＣｕＫα射线 ,…     

质量控制图原理在股票投资组合中的应用研究

质量控制图是用来控制生产过程质量的一种统计方法。其基本理论方法应用到股票投资组合中,可以降低投资风险,提高投资组合的收益率。通过实证研究表明:利用质量控制图原理来确定投资组合的选股、买点和卖点,可以使投资组合获得明显高于大盘指数的收益率,从而验证了质量控制图的基本理论方法完全可以应用于股票投资决策,并且具有显著的实际应用价值。     

三维内肋管内插入螺旋扭带的强化传热实验

本文分别以水和乙二醇为工质，在Ｒｅ数范围为：６００～４００００，Ｐｒ数范围为：５．５～１１０之间，对四根分别插入三种不同扭率螺旋扭带的三维内助管内的换热和流阻特性进行了实验研究。结果表明：三维内肋管内加装扭带的强化传热技术适用于低Ｒｅ数下高Ｐｒ数工质的管内对流换热强化。根据实验值得到了流阻和换热关联式。     

Studies on toxicological mechanisms of gas-phase cigarette smoke and protection effects of GTP

Gas-phase cigarette smoke (GPCS) was able to induce lipid peroxidation in lecithin liposomes, rat liver microsomes, and rat lung cells (RLC), and change the membrane fluidity of RLCs. Lipid free radicals were trapped in a GPCS-treated microsomal suspension by using 4-POBN as the spin trap. In addition, it was found that GPCS-peroxidized liposomes in appropriate degree of lipid peroxidation had the ability to increase the generation of superoxide anions in rat peritoneal neutrophils (RPN). Effects of green tea polyphenols (GTP) on the GPCS-induced damages were investigated The results showed that GTP was capable of inhibiting the GPCS-induced damages.     

动态光散射实验

动态光散射技术是测量纳米及亚微米颗粒粒径的有效方法．本文介绍了动态光散射实验的原理、实验装置及方法，并测量了粒径为85nm的聚苯乙烯水溶液的粒径，分析了实验产生误差的原因．     

催化动力学测定痕量砷(Ⅲ)

在醋酸介质中,发现痕量砷(Ⅲ)能灵敏地催化高碘酸钾氧化靛红la褪色的指示反应,研究了该催化反应的最佳条件与动力学参数,建立了一种新的测定痕量砷(Ⅲ)的方法。该法的线性范围0.0-40μg/LAs(Ⅲ),检测限为1.92×10-6g/L,用于环境水样中砷(Ⅲ)的测定,获得了满意的结果。     

Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Photocatalytic Synthesis of Oxygenates from Gaseous CO2 and CH4 over Semiconductor

Photoinduced synthesis of CO2 and CH4 was investigated using a batch reaction system on several photoactive materials supported on silicon dioxide. Single semiconductor showed higher selectivity to C1 compounds. The production of C2-C3 oxygenates took place preferentially on composite semiconductor photocatalysts. In particular, it was found that acetone was the primary product over Cu/CdS-TiO2/SiO2.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.